You can't just load the stuff from the machine disks last I knew. However, I think they had to pay for it with the machine buy. Offline software, if I remember right we did have it. ![]() It would take a cut that was impressive (for the nature of the machine), sometimes it was hard to keep the toolpost 'right' however:) 3. The one I used had a nice 'strong' motor, and gear drive. You could see the G code the machine generated from it's software but that was about all. ![]() Have an old computer with Dos 6.22 on it already.Īlso, does anyone know if this machine can be programed with g code? Raw Message Hi Dave, We had one of those where I used to work. It would be great if I could acquire a Desktop version of the software so I could practice programming at home. No one in the shop has any more than a casual knowledge of. Is there a Desktop or offline version of the software available?Īt work, I have been assigned the task of programming an old Bridgeport EZ-Path I lathe. ![]() No one in the shop has any more than a casual knowledge of programming this machine, and the boss claims that this machine/software is no longer supported. Raw Message At work, I have been assigned the task of programming an old Bridgeport EZ-Path I lathe.
0 Comments
Leave a Reply. |